FIRST, it's important to know that mophead hydrangeas do not have to be pruned back - ever - unless they are very old. Removing dead stems is the only pruning that must be done for the health of the plant, and these can be removed at any time. Dead blooms can also be removed at any time.

But if your hydrangea is getting much too large (or old), and you simply must prune it, use one of the following methods.

Use Method One if you have mophead or lacecap hydrangeas (these are the only type hydrangeas that are usually blue or pink) or if you have Oakleaf hydrangeas (leaves shaped like large oak leaves, white blooms).

Use Method Two if you have paniculatas (PeeGees) or 'Annabelle' (arborescens

Pruning: Method One

USE METHOD I FOR:

• Mophead and Lacecaps (macrophyllas - usually pink or blue)
  
• For Oakleaf hydrangeas (white blooms, leaves shaped like oak leaves)

Summary of Method I:
Prune these hydrangeas only in the summer BEFORE August (to be safe). Some experts believe these hydrangeas may be pruned even into August, but this might be risky. The hydrangeas may already have set their bloom buds for the next year.

Method I is for hydrangea types that bloom on OLD WOOD. ("Old Wood" are stems that have been on the hydrangea since the summer before the current season. "New wood" are stems that developed on the plant during the current season) This group of hydrangeas produce flower buds on hydrangea stems around August, September or October for the following summer's blooms. If those stems are removed (pruned) in the fall, winter, or spring, the bloom buds will be removed, and there may be little or no bloom the following summer (usually June/July for the northern hemisphere).

Note that pruning is not the same thing as removing the dead blooms. (See below "Removing Old Blooms.") There exists a small group of mophead hydrangea that will bloom no matter when they are pruned. ('Endless Summer' is this type of hydrangea). Your garden center can tell you when you purchase a hydrangea if it is in this special category called "everbloomers." But for the vast majority of hydrangeas, pruning after July will likely result in fewer blooms the next summer.

THERE ARE CERTAIN INSTANCES WHEN PRUNING CAN BE HELPFUL:

(1) All dead stems should be removed from hydrangeas every year.

(2) After the plants are at least 5 years old, about 1/3 of the older (living) stems can be removed down to the ground each summer. This will revitalize the plant.

(3) In addition, if it becomes necessary to prune a plant to reduce its size, it may be cut back in June or July without harming the next year's bloom. But it will return almost immediately to it's former size. This is one reason why it's best to plant a hydrangea where it does not have to be pruned.

REMOVING OLD BLOOMS

Removing old blooms on a plant is called "Deadheading."

Fortunately, we can remove the old blooms at any time of the year without harming the bloom for the following year. In June and July you may remove them in any way you would like (long stems or short stems). Here are some tips for deadheading:

(1) When you cut blooms for arrangements in June or July, you can cut them with long stems because the bloom buds haven’t set for the following year. (2) When you cut the blooms after the first of August, it would be safest to remove them with very short stems so you won’t disturb any developing bloom buds for next year. As long as you cut above the first set of large leaves, you will be fine.

EXCEPTIONS: For all mophead hydrangeas, the above method of pruning (Method I) will work very well. However, one may become confused when a neighbor or friend prunes his or her hydrangea in the fall or spring, and his hydrangea blooms just fine. Unlike most mophead hydrangeas, there are a few that will regenerate the bloom buds after the first set is destroyed. These hydrangeas are known as 'remontant'. They seem to be found most abundantly in gardens in more northern regions of the U.S. and Canada. Therefore, on these special hydrangeas, if the bloom buds are killed by frost or pruned off at the wrong time, they will regenerate the bloom bud and bloom as usual. ('Endless Summer' is just such a hydrangea.) To the right is a picture of a hydrangea that has this trait. It was sent to me by Donna from New Britain, CT. I don't believe she has a name for it. Donna says that she pruned this hydrangea in November, and, as we can see, it was covered in bloom the following summer.

Pruning: Method Two

USE METHOD II FOR:

• For paniculata (such as PG and 'Limelight') and 'Annabelle'
  

Method II is USED FOR: H. arborescens (Annabelle types) and H. paniculata (PeeGee types) hydrangeas. These types of hydrangeas bloom on new wood (new stems). It is a joy to grow these type hydrangeas because they are determined to bloom every single year, no matter how they are treated. The only time they cannot be pruned is in the spring ('Annabelle') or in the summer (PG) when they are preparing to bloom.

Many people grow hedges of Annabelle and cut them within a few inches of the ground each fall so they will not be an eyesore during the winter. They will still bloom beautifully in the spring/summer, however this drastic pruning may not allow stems to increase in size, and they may need staking to hold up the large heads. Go to the page on 'Annabelle' for a more detailed description of the pros and cons of pruning this hydrangea to the ground. While at the 'Annabelle' page, view a picture of Penny McHenry's 'Annabelle' hedge.

Paniculatas (PG/Limelight types) can be pruned in the fall, winter, or spring. However, it is not necessary to prune them every year. It is suggested that one trim out crossing branches and those that do not contribute to an attractive form whenever necessry.

Paniculata hydrangeas are the only hydrangeas that can be pruned into a tree-form. If one is attempting to grow a paniculata as a tree, the developing trunk and main top branches should not be removed. If a panicultata that is trained into a tree-form is cut or broken off close to the ground, it will grow back as a shrub unless the training and pruning is started again from the new shoots.